Harmonic NSG 9116 Hardware Installation page 45

Cabling and Configuration
2. Click <Enter>.
3. Browse through the alarms/warnings, using the <Down or Up> keys.
Monitoring ETH ports MAC Address
To monitor the ETH1 MAC Address
1. Navigate to the Network Config screen and click <Enter>.
2. Click <Enter>. The ETH1 IP Address screen appears.
3. Click <Down or Up> until the ETH1 MAC Address screen appears.
To monitor the ETH2 MAC Address
1. Navigate to the Network Config screen and click <Enter>.
2. Click <Down or Up> to open the Ethernet Port 2 screen.
3. Click <Down or Up> until the ETH2 MAC Address screen appears.
Monitoring Product Information
The Product Information screen is related to the following sub-screens:
When a warning is displayed, the following sign appears at the top
right corner of the LCD display: (W).
The Ethernet Port 1 screen appears.
The Ethernet Port 1 screen appears.
Unit Information - allows to view unit type, unit version and unit S/N.
Main Board Information - allows to view main board type, user and
S/N.
Interface Information - allows to view interface type, version and
FPGA.
Software Information - allows to view boot version, firmware version
and main FPGA version.
LCD Hotkeys Help - allows to view the various available hotkeys.
Preliminary Configuration of the NSG 37