Harmonic NSG 9116 Hardware Installation page 37

Cabling and Configuration
To switch to Config mode:
1. Navigate to the Setup screen, using the <Up & Down> keys.
2. Click Enter. The Operation Mode screen appears.
3. Click <Enter>. You are prompted to enter a password.
4. Type in a password and click <Enter>.
5. To select the Config mode, click <Down or Up> and then <Enter>.
Editing Tips
You may edit parameters only in Config mode. If you are in Monitor
mode and you are trying to edit parameters, you are prompted to enter a
password and switch to Config mode.
To start an editing session:
The Change Op. Mode screen appears with a blinking cursor.
The Operation Mode screen appears indicating the current operation
mode. After thirty minutes of inactivity, the Configure mode changes
automatically to the Monitor operation mode.
Click Enter:
The screen name changes to Edit (screen name).
A blinking cursor appears on the first character of the second line of
the screen.
Preliminary Configuration of the NSG 29