Fayat Group BOMAG BT 60/4 Operating Instructions Manual page 21

Operation
Fig. 13
Pull the rope by the starter handle (Fig. 13) un-
G
til resistance can be felt.
Let the starter handle run back to initial posi-
G
tion.
Fig. 14
Pull the starter handle quickly and with power
G
(Fig. 14).
Caution
!
Do not let the starter handle hit back.
Guide the starter handle back to initial position
G
by hand.
If the engine does not start during the first at-
G
tempt, repeat the starting process.
22
Fig. 15
Open the choke (Fig. 15) 3 to 6 seconds after
G
the engine has started running.
Fig. 16
Set the throttle lever (Fig. 16) to position "MIN"
G
and let the engine run warm for 1 to 2 minutes.
i Note
Once the engine has warmed up you can start to
work with the tamper.
Starting under cold weather conditions
If the engine stops again after approx. 3 to 5
G
seconds, close the choke again and repeat the
starting process.
Engine oil level too low
The engine does not start if the oil level is too low.
Check the engine oil level, fill up if necessary.
G
Repeat the starting procedure.
G
BOMAG
BT 60/4 BT 65/4