Regulatory Compliance And Safety Information; Safe Use And Installation Instructions - Onlogic ML100G-51 Manual

Revision History
Revision History
Release of ML100G-51/52 manual

Regulatory Compliance and Safety Information

Regarding equipment: Industrial Fanless PC model(s): xxxxxML100G-51xxxxx and xxxxxML100G-52xxxxx
(where x is any alphanumeric character, "-" or blank designating configuration differences)

Safe Use and Installation Instructions

1. Do not open or modify the device. The device uses components that comply with FCC and CE
regulations. Modification of the device may void these certifications.
2. Install the device securely. Be careful handling the device to prevent injury and do not drop.
3. Wall or ceiling mounting device requires use of a mounting plate or bracket. Plate or bracket must be of
metal construction and have a minimum thickness of 1mm.
4. Use M3x0.5mm Flat Head screws to attach mounting plate or mounting brackets to threaded holes on
bottom or rear of chassis. Screws should be minimum length of 4mm. Add 1mm of screw length for
every milimeter of additional thickness of plate or bracket beyond 1.5mm.
5. Ambient operational temperature must be between 0 °C to 40 °C, or with some configurations
0 °C to 50 °C , with a non-condensing relative humidity of 10-90%.
6. The device can be stored at temperatures between -40 °C to 85 °C.
7. Keep the device away from liquids and flammable materials.
8. Do not clean the device with liquids. The chassis can be cleaned with a cloth.
9. Allow at least 2 inches of space around all sides of the device for proper cooling. If device is mounted
to vertical surface then recommended device orientation so that heatsink fins allow air to rise
unobstructed. Alternative orientations may result in reduced operational temperature range.
10. This device is intended for indoor operation only.
11. Use UL Listed external power supply with rated output 12Vd.c., 5A min.
12. Install the device only with shielded network cables.
13. Service and repair of the device must be done by qualified service personnel. This includes, but is not
limited to, replacement of the CMOS battery. Replacement CMOS battery must be of the same type as
original.
14. Proper disposal of CMOS battery must comply with local governance.
ML100G-51/52 Industrial Computer
Date
7/31/2019
4