Errors While Scanning; Imaging Preferences Parameter Defaults - Symbol DS6707 Product Reference Manual

5 - 2 DS6707 Digital Imager Scanner Product Reference Guide
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Imaging Preferences Parameter Defaults

Table 5-5 lists the defaults for imaging preferences parameters. There are two ways to change the default
values:
• Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
• Download data through the device's serial port using SSI. Hexadecimal parameter numbers are shown in
this chapter below the parameter title, and options are shown in parenthesis beneath the accompanying
bar codes. See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for
changing parameters using this method.
See
NOTE
and miscellaneous default parameters.
Imaging Preferences Parameter Defaults
Table 5-5
Parameter
Decoding Options
Operational Modes
Image Capture Autoexposure
Image Capture Illumination
Fixed Exposure
Fixed Gain
Gain / Exposure Priority for Snapshot Mode F1h 32h
Snapshot Mode Timeout
Snapshot Aiming Pattern
Image Cropping
Crop to Pixel Addresses
Image Size (Number of Pixels)
Image Brightness (Target White)
Appendix A, Standard Default Parameters
Parameter Number
N/A
F0h 68h
F0h 69h
F4h F1h 37h
F1h 38h
F0h 43h
F0h 2Ch
F0h 2Dh
F4h F0h 3Bh; F4h
F0h 3Ch; F4h F0h
3Dh; F4h F0h 3Eh
F0h 2Eh
F0h 86h
Set Default Parameter on page
for all user preferences, hosts, symbologies,
Default
N/A
Enable
Enable
100
50
Autodetect
0 (30 seconds)
Enable
Disable
0 top, 0 left, 1023 bottom, 1279 right
Full
180
4-4.
Page
Number
5-4
5-5
5-6
5-6
5-7
5-7
5-8
5-9
5-9
5-10
5-11
5-12