Symbol LS 3070 Product Reference Manual page 46

LS 3070 Product Reference Guide: Interface Guide
Third: Install the Cable Internally
The base station cable is installed internal to the IBM 3683/84 with the cable
exiting the rear of the terminal.
1. Remove the printer assembly as follows:
Disconnect the printer ground strap (slide on connector) from the right
•
side of the printer, as shown in
Slide the two printer locking tabs (black plastic) toward the front of the
•
register while pressing downward, as shown in
Lift the printer up and out.
•
2. The cable to be installed is illustrated in
3. Mark an X on the side of J16 that faces the front of the terminal. Remove the
J16 connector from the keyboard connector bracket. Slide the J16 connector
under the printer mounting plate. See
4. Using a small screwdriver, remove the cable access door from the rear of
the register. Position the cable to connect J2 to J16 using the jumper PCB.
Make sure J2 and J16 are positioned so that the X and • align. (Some cables
are marked with TERM rather than •.) Use the tie wraps provided to secure
the connection. See
5. Slide J1 under the printer mounting plate to the keyboard access opening.
Pull it through the opening and secure it with the retaining clips (where J16
originally was). See
Keyboard rather than •.)
6. Push the J2/J16 connection under the printer mounting plate. Replace the
cable access door at the rear of the register.
7. Replace the printer assembly as follows:
Attach the ground strap to the right side of the assembly.
•
Fasten the locking tabs by sliding them toward the rear of the register.
•
Figure
Figure 5-11.
Figure 5-12. (Some cables are marked with KBD or
5-7
5-7).
Figure
Figure 5-9.
Figure 5-10.
5-8.