Channel Set Up; Deleting (Or Adding) Channel(S) - Sylvania SRCD427P Owner's Manual

CHANNEL SET UP

You can program the tuner to memorize all the chan-
nels you receive in your area.
NOTE: Channel memory programming is NOT
needed when connected to a cable box or satellite
box. Just select the TV/VCR/DVD channel to the
output channel of the cable box or satellite box (Ex
CH3), then select the channel to be viewed on the
Cable Box or Satellite Box.
Make sure ...
•
The unit is turned on.
1
Select "CHANNEL SET UP"
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
point to "CHANNEL SET UP".
Then press the ENTER button.
2
Begin auto ch programming
Press the Arrow button K or L to
point to "AUTO CH PROGRAM-
MING".
Then press the ENTER button.
The tuner scans and memorizes all
the active channels in your area.
3
After scanning
The tuner stops on the lowest memorized channel.
•
When AUTO CH PROGRAMMING is activated
where there is no TV signal input, "NO TV SIG-
NALS" will appear on the display after the com-
pletion of the channel scanning.
•
The unit may memorize TV channels as CATV
channels if reception conditions are poor. If this
happens, check the antenna connection and try the
AUTO CH PROGRAMMING again, or wait until
reception conditions are better and then try it again.
TV/VCR
The channels you no longer receive or seldom watch
can be deleted from the memory. (Of course, you
can add the deleted channel into the memory again.)
1
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
point to "CHANNEL SET UP".
Then press the ENTER button.
2
TV/VCR SETUP -
Press the Arrow button K or L to
TIMER PROGRAMMING
SETTING CLOCK
point to "ADD/DELETE CH".
B CHANNEL SET UP
USER'S SET UP
V-CHIP SET UP
Press the ENTER button.
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
3
Press the Arrow button K or L
– CHANNEL SET UP –
until your desired channel number
ADD / DELETE CH (CATV) appears. (You can also use the
B AUTO CH PROGRAMMING
number buttons or the CHANNEL
K or L button to enter it)
(Example: CH8)
•
You must precede single-digit channel numbers
with a zero (Example: 02 ... 09).
•
When selecting cable channels which are higher
than 99, press the +100 button first, then press the
last two digits. (Example: to select channel 125,
first press the +100 button then press "2" and "5").
4
Press the ENTER button. The channel number
changes to light red. The channel is deleted from
memory.
•
To delete another channel, repeat steps [3] to [4].
•
If you press the ENTER button again, the channel
is memorized again.
Added channel: Light blue.
Deleted channel: Light red.
5
Press the SETUP button on the remote control to
return to TV mode.
NOTE: To confirm that channel(s) has been deleted
or added, press the CHANNEL K or L button.
- 18 -
DELETING (OR ADDING)
CHANNEL(S)
Select "CHANNEL SET UP"
Select "ADD/DELETE CH"
Enter the desired channel number
Delete (or add) it from (into) memory
Exit the channel setup mode
TV/VCR
TV/VCR SETUP -
TIMER PROGRAMMING
SETTING CLOCK
B CHANNEL SET UP
USER'S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
– CHANNEL SET UP –
B ADD / DELETE CH (CATV)
AUTO CH PROGRAMMING
08
ADD / DELETE
EN
1C29