Table of Contents
Advertisement
xcvrs_3-2002.fm Page 3 Tuesday, April 2, 2002 3:23 PM
Installation Steps
To install the HP Procurve High-Speed Transceivers, follow these steps:
1. Fully insert the transceiver into an HP networking device's transceiver
slot until the transceiver "snaps" into place, and secure the transceiver
with the retaining screws.
If the transceiver slot is in a module that has not yet been installed into
the switch, then install the module into the switch.
2. For the Series 2300 and 2500 Switches, reset or reboot the switch.
3. Connect the network cable to the transceiver and check the transceiver
and network device for correct operation.
Details on these steps are provided in the rest of this document.
Insert the Transceiver Into the Slot
The transceivers are installed into an HP networking device, as follows:
1. Using a flat-bladed or Torx T-10 screwdriver, unscrew the two retaining
screws on the slot cover plate or existing transceiver, and remove it
from the module or device. Retain the cover plate for possible future
use.
loosen these screws and remove the cover plate
2. Touch a grounded, metal object (such as a powered-on switch) to
discharge any static electricity on your body, then carefully remove the
transceiver from its protective anti-static packaging. Hold the trans-
ceiver by its bulkhead or edges, taking care not touch any of its board
components or metal connectors.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
g
g
3
Advertisement
Table of Contents
