Advertisement
Installation Steps
C a u t i o n
To avoid possible damage to the transceiver circuitry, turn off power to the
device before installing the transceiver into it. If you are installing the
transceivers in the Switch 2424M Gigabit Stacking Module, you can leave
the power on to the switch, but remove the module from the switch before
installing transceivers into it.
To install the HP Gigabit Transceivers, follow these steps:
1. Insert the transceiver into an HP networking device's Gigabit
transceiver slot and secure the retaining screws.
2. If the Gigabit transceiver slot is in a module, install the module into the
switch.
3. As necessary for the type of networking device into which the trans-
ceivers are installed, apply power to the device.
4. Connect the network cable to the transceiver and check the transceiver
and network device for correct operation.
Details on these steps are provided in the rest of this document.
2
Advertisement
