Troubleshooting - Klarstein Clearcube Manual

• For both of the water tank and the big water reservoir, clean them with diluted
detergent, warm water and a soft cloth. Then use the water to rinse the inside, and
drain out the water from the draining port by unplugging the drain cap on the back.
It will help you keep the unit and ice-cube hygienicly, and also make the unit work
normally.
How to drain out the water
Because the water in the big water reservoir is stop to drain port by the water valave,
if you want to drain away all the water, please plug on the unit and but don't start the
unit, then remove the drain port cap at the back. Wait some minutes, all of the water will
flow out.

TROUBLESHOOTING

Problem
"REFILL WATER" indicator
is on.
"REMOVE ICE" indicator
is on.
The big reservoir full
of wa-ter, but "REFILL
WATER" indi-cator is
always on.
No water flow out from
the water separator pipe.
Possible cause
Lack of Water.
There is too much ice.
The water is distillation
water, it is too pure.
The water filer at bottom
of the water reservoir is
blocked. And water can't
enter into the lower water
tank.
The hole on the wall of
the wa-ter separator is
blocked.
Suggested solution
Stop the ice maker, fill
water from the top big
water reservoir up to
MAX. mark, then press
"ON/OFF" button again
to restart the unit.
Remove ice from ice
basket.
Chang the water to nomal
potable water or mineral
water.
Clean the water filter.
Use slim wire to prick each
hole, till the water can
flow out easily.
EN
21