Table of Contents
Advertisement
SPECIFICATIONS
Air Pressure: 90 to 120 PSI (lbs./in2 gage) (600 to 1200 kPa). Line pressure over 150 PSI requires a regulator and relief valve
upstream of air hose.
Air Inlet Threads: ¼ inch PTF (Seal with thread tape).
Shake Angle: If opera�ng at over 120 PSI pressure, the shake angle must be set to 30° (see page 4) with a full gallon can
clamped, air at maximum normal line pressure. The shaker is supplied with a 30° shake angle. (See "OPERATION")
Air Consump�on: Approximately 4.3 CFM (0.002 M3/sec) free air with 1 gallon (U.S.) 12 lb. can at 30° shake angle.
Speed: 135RPM to 800 RPM. Suggested at 700 cycles/minute at 30° shake angle. Adjustable at control valve, automa�cally
compensates for can size.
Capacity: The shaker can hold half liter cans, and pint cans through four liter round cans. Including gallons, imperial gallons,
most aerosols (with caps) and square gallons.
Maximum Shake Weight: The suggested maximum weight is 16 lbs. gross can weight.
Recommended Shake Time: Refer to your paint manufacturers recommenda�on.
Final Filter: Bronze, spring-retained 40 micron element behind inlet elbow (M-307).
Oil Consump�on: Install the automa�c lubricator and adjust the lubricator by the turning ver�cal line on the drip rate dial
clockwise un�l it stops and then turn it counter clockwise to number 4. When not using the lubricator, add three drops of air
tool oil at air inlet before every use. Allow a ten minute maximum opera�on �me between manual oiling.
Recommended Oil: Petroleum 5W to 10W Non-detergent Rust Inhibi�ng Air Tool Oil such as Lubriplate Rockwell 10R. Oil
should not contain gum removers or petroleum dis�llates. Do not use motor oil. Never use silicone oils or grease in a paint
shop.
Grease: Mul�purpose calcium or lithium-based chassis grease. Re-lubricate both Zerk fi�ngs every 3 to 6 months, or more
o�en in severe service.
Cyclone Air Shaker - Dedoes PN# 0910P
20cm W x 26.5cm D x 35.5cm H (8in W x 10.5in D x 14in H)
Weight: 9 kgs (20 lbs)
Pedestal - Dedoes PN# 0915P
27cm W x 21cm D x 78cm H (10.75in W x 8.25in D x 30.75in H)
Weight: 7 kgs (15 lbs)
For technical support on our products or addi�onal accessories, please call us at 248-624-7710 or visit our web site: www.dedoes.com
Page 5
Cyclone Paint Shaker User Manual
Part No: 0910P (Shaker) / 0915P (Pedestal)
PART # M-312 KD RV.8 2019-09-25
Advertisement
Table of Contents
