Dedoes Cyclone 0910P User Manual page 3

Pneumatic paint shaker
Table of Contents

Advertisement

ASSEMBLY NOTES:
Item
Piston Screw & Rod End
M-279 & M-286
Relief Jam Nut
Inlet Ell
Cylinder Stud
Cylinder Stud & Jam Nut
Crank Arm
Inlet Fi�ngs
U-Bolt Nuts
Jaw Bolt Nuts
Cylinder Assembly
Rod End
All parts must be completely clean and lubricated before assembly or rapid wear may result.
*NOTE: Thread Seal: Non-hardening gasket cement (Permatex "Avia�on Form-A-Gasket" or equal).
Thread Lock: Lubrica�ng, anaerobic hardening thread locking compound (Loc�te 271, "Stud-N-Bearing Mount", or equal).
**(One lb. In. equals 1/12 of one lb. Ft.).
REMEMBER TO:
· Bolt the shaker down securely.
· Seal the shaker to the pedestal with non silicone elas�c sealant.
· Provide a drainage hole beneath the shaker when bench top mounted.
· Mount the lubricator on a wall pipe or directly onto the shaker.
· Fill the lubricator bowl with air tool oil to the fill line.
· Keep the lubricator to shaker hose under 4 foot long. Avoid air line low spots (water traps).
· Install an air filter if there's water/dirt in the air line.
· Be sure the shaker gets enough air tool oil during opera�on.
For technical support on our products or addi�onal accessories, please call us at 248-624-7710 or visit our web site: www.dedoes.com
Page 3
Cyclone Paint Shaker User Manual
Part No: 0910P (Shaker) / 0915P (Pedestal)
PN#
Torque
Thread Lube Notes
20-25 �-l b
M-299
15 �-l b MAX**
M-307
5 �-l b
M-277
5 �-l b
15 �-l b (Ja m)
M-289
28 �-l b
M-243
15 �-l b
M-251
28 �-l b
Oil, torque evenly Level the U-Bolt while torquing.
M-251
15/18 �-l b
N/A
M-286
20 �-l b
Threa d Lock*
Heat to 550°F to disassemble.
N/A
Adjust to leave one nut thickness of the threads exposed.
Threa d Sea l
Threa d Lock
N/A
Tighten un�l the shock bushing swells to the washer diameter.
N/A
Install the nut away from the housing.
Threa d Lock
N/A
N/A
Remove the retaining ring & pull internals together with the rod end to disassemble.
Threa d Lock
Remove the seals, heat to 550°F to break the thread lock, and install new rod seal.
PART # M-312 KD RV.8 2019-09-25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cyclone 0915p

Table of Contents