We hope that you will enjoy using this tool for many years. INTENDED USE Your Black & Decker angle grinder has been designed for cutting metal and masonry using the appropriate type of cutting or grinding disc. It is also suitable for sanding using a backing pad and sanding disc.
E N G L I S H General 1. Keep work area clean Cluttered areas and benches can cause accidents. 2. Consider work area environment Do not expose the tool to rain. Do not use the tool in damp or wet conditions. Keep the work area well lit.
PACKAGE CONTENTS The package contains: 1 Angle grinder 1 Side handle 1 Grinding or cutting disc 1 Flange set 1 Two-pin spanner 1 Instruction manual Carefully unpack all parts.
E N G L I S H ASSEMBLY Before attempting any of the following operations, make sure that the tool is switched off and unplugged and that the disc has stopped rotating. Removing and refitting of the guard Never use the tool without the guard, except when sanding.
Fitting Remove the guard as described above. Place the inner flange (12) onto the spindle (9) as shown (fig. H). Make sure that the flange is correctly located on the flat sides of the spindle. Place the backing pad (16) onto the spindle. Place the sanding disc (17) onto the backing pad.
3a. Sección de Bosques de las Lomas Delegación Cuajimalpa, 05120, México, D.F. Tel. (52) 555-326-7100 R.F.C.: BDE810626-1W7 Black & Decker del Perú S.A. Av. Enrique Meiggs 227. Pque. Industrial - Callao Teléfono: (511) 452-5577 RUC 20266596805 Impreso en China Printed in China 478306-00 09/14/07...