Husqvarna 535FBX Operator's Manual page 18

• Use the stop at the base of the cutting head to
provide support during cutting. This will help prevent
the cutting attachment from bouncing on the branch.
• Make an initial cut on the underside of the branch
before cutting through the branch. This will prevent
tearing of the bark, which could lead to slow healing
and cause permanent damage to the tree. The cut
should not be deeper than ⅓ of the branch thickness
to prevent jamming. Keep the chain running while
you withdraw the cutting attachment from the branch
to prevent it jamming.
To prepare the product for start
1. Push the air purge bulb again and again until the fuel
starts to fill the air purge bulb.
Note: It is not necessary to fully fill the air purge bulb.
18
2. Move the choke control up into choke position.
WARNING: Be careful, risk of cut
injuries. The saw chain starts to rotate
immediately when you start the engine
with the choke.
To start the product
WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope again and again until the engine
starts.
7. Reset the choke when the engine fires.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.
Safety 535FBX on page 5 ).
1301 - 003 - 20.11.2019