Husqvarna 535FBX Operator's Manual page 14

To set the work height
1. Pull out the cord to the necessary work length and
make a knot.
2. Install the knot to the suspension ring on the shaft.
3. To make the cord shorter, pull the cord up by the top
part of the load reducer. The load reducer
automatically winds the cord when the tension
decreases.
To set the product in transport position
1. Loosen the knob and remove the top part of the load
reducer.
14
A
B
2. Attach the top part (B) of the load reducer to the
bottom part (A) of the load reducer.
3. Turn the knob 3 turns or more to loosen the coupling
on the shaft.
4. Push and hold the button (C).
C
5. Hold tight in the end of the shaft that the engine is
attached to.
6. Pull the attachment straight out of the coupling.
B
A
1301 - 003 - 20.11.2019