Husqvarna 135R Operator's Manual page 8

3. Push the throttle trigger lockout (A) and make sure
that it goes back to its initial position when you
release it.
4. Start the product and apply full throttle. Refer to
start the engine on page 16 .
5. Release the throttle trigger (B) and make sure that
the cutting attachment stops.
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
The cutting attachment guard prevents injuries and
stops objects that eject in the direction of the operator.
1. Stop the engine.
2. Do a visual check for damages, for example cracks.
8
3. Replace the cutting attachment guard if it is
damaged.
To do a check of the vibration damping system
WARNING: Make sure that the engine is off
and that the stop switch is in STOP position.
1. Make sure that there are no cracks or deformation
on the vibration damping units. Replace the vibration
damping units if they are damaged.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
To
To do a check of the quick-release mechanism
WARNING: Do not use a harness with a
defective quick-release mechanism.
The quick-release mechanism lets the operator remove
the product quickly from the harness if there is an
emergency.
1. Stop the engine.
2. Do a visual check for damage, for example cracks.
3. Release and attach the quick-release mechanism to
make sure that it operates correctly.
To do a check of the muffler
WARNING: Do not use a product with a
defective muffler.
WARNING: The muffler becomes very hot
during and after operation and also at idle
speed. Use protective gloves to prevent
burn injuries.
The muffler keeps noise levels to a minimum and points
exhaust fumes away from the operator.
1. Stop the engine.
2. Do a visual check for damage and deformation.
975 - 003 - 08.10.2019