Table of Contents
Advertisement
Available languages
Available languages
GB
correcTIon oF mAlFuncTIonS
ProBlem
A. There is paint leakage
on the roller arm
assembly
B. Piston rod does not
move when the switch is
pressed
C. The fill tube will not fill
with paint or paint leaks
from fill valve
Locking cap
Retaining disk
Duckbill valve
Valve housing
noTIce: If after extended use you find the plunger difficult to pull while
i
filling, apply a generous amount of petroleum jelly around the o-rings
located at the end of the plunger (Fig. 2). we have included a packet of
petroleum jelly for you convenience.
10
cAuSe
1)
The seal on the arm is backward.
2)
The seal and cap were not properly
cleaned.
3)
The O-ring and the connecting area
were not cleaned properly.
4)
Paint residue on connecting areas
5)
The O-rings are damaged or
missing
6)
The roller cover is worn or
damaged
7)
The core or cap is worn or
damaged
8)
The roller arm is worn
1)
Lever is set to "MANUAL"
2)
Batteries too weak
3)
Batteries incorrectly inserted
4)
O-rings are not lubricated
5)
Piston rod is jammed
1)
Paint residue on fill valve
components
1)
Unscrew the locking cap on the valve housing by
turning counterclockwise.
2)
Remove the retaining disk and the duckbill from
the valve housing
3)
Clean these parts thoroughly using the appropriate
cleaning solution.
4)
Replace the duckbill valve and retainer disk.
5)
Screw the locking cap on the valve housing by
turning it counterclockwise.
Connecting
area
TurboRoll
SoluTIon
1)
Turn the seal around
2)
Clean and properly lubricate
3)
Clean and properly lubricate
4)
Clean connecting areas
5)
Replace the O-rings
6)
Replace roller cover
7)
Replace core or cap
8)
Replace roller arm
1)
Set lever to "POWER"
2)
Replace
3)
Insert correctly (note marking
in battery compartment)
4)
Lubricate the O-rings on the
plunger
5)
Set lever to "MANUAL" and
release piston rod by pushing/
pressing
1)
Insert fill tube firmly into
fill valve and twist fill tube
several times to break up
paint residue.
2)
If the problem persists, refer to
the steps below to clean the fill
valve components.
Advertisement
Table of Contents
