Clock Functions - AEG BEB351010M User Manual

10 www.aeg.com
The maximum capacity of the cavity
embossment is 250 ml.
Fill the cavity embossment with water
only when the oven is cold.
CAUTION!
Do not refill the cavity
embossment during
cooking or when the
oven is hot.
2. Set the function:
3. Turn the control knob to set
temperature.

7. CLOCK FUNCTIONS

7.1 Clock functions table
Clock function
TIME OF DAY
DURATION
END
TIME DELAY
MINUTE MINDER
7.2 Setting the time. Changing
the time
You must set the time before you
operate the oven.
The flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer
is not set.
Press the
time.
.
Application
To set, change or check the time of day.
To set how long the appliance operates.
To set when the appliance deactivates.
To combine DURATION and END function.
To set countdown time. This function has no effect on the
operation of the appliance. You can set the MINUTE MIND-
ER at any time, also when the appliance is off.
or to set the correct
4. Preheat the empty oven for 10
minutes to create humidity.
5. Put food in the oven.
Refer to "Hints and tips" chapter.
Do not open the oven door during
cooking.
6. Turn the knob for the heating
functions to the off position to turn
off the oven.
7. Remove water from the cavity
embossment.
WARNING!
Make sure that the oven
is cold before you
remove the remaining
water from the cavity
embossment.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
To change the time of day press
again and again until
7.3 Setting the DURATION
1. Set an oven function and
temperature.
2. Press again and again until
starts to flash.
starts to flash.