Advertisement
TImING USING THE «FLYBACk» FUNCTION*
With the "Flyback" function you can make rapid successive time measurements with a single press
on button
, without needing to stop and reset the counters before restarting the chronograph.
B
Note: since this function does not stop the chronograph before restarting a new measurement, the
result can only be read on the go. So you are advised to observe the measured time properly before
pressing the flyback button
1. Press button
to start the first time measurement.
A
2. Press button
: the chronograph will restart immediately for a second time measurement.
B
3. Press button
again for each consecutive time measurement.
B
4. Press button
to stop the chronograph; the elapsed time of the latest measurement will be
A
indicated by the counter hands 5, 6 and 7*.
5. Press button
to reset the counters.
B
*According to model
FIxED BEzEL WITH TACHYmETER SCALE*
You can use the tachymeter scale in combination with your chronograph to determine your average
speed over a given distance of 1 km or 1 mile, for a speed of more than 60 km/h or 60 miles/h, or for
a travel time of under 60 seconds.
To determine your average speed, start the chronograph at the start point, and stop it at the end point
of a 1 km or 1 mile trip stage. The numeral on the tachymeter scale to which the seconds counter hand
5 is pointing corresponds to the average speed of travel in km/h or miles/h.
*According to model
.
B
Advertisement
