Cleaning; Top Tips - Morphy Richards 48955 User Manual

48955MCZamended 9/1/07
10
4:32 pm Page 10
• Align the flats of the shaft end to
approximately the same angle as
that of the drive and insert into the
drive P.
• Rotate the attachment slightly until it
locates to the drive and push into
place Q.
• Release the attachment retainer pin
and rotate the attachment slightly
until the hole on the attachment
locates to the retainer pin on the
main unit drive hub R.
Operating Instructions
• The fine shredder is for finely
shredding and the coarse shredder is
for coarsely shredding hard or crisp
vegetables (e.g. carrots, turnips,
potatoes, but also hard cheese, nuts
and dry bread).
• The thick slicer is for slicing firm
foods. It is particularly suitable for
preparing vegetables to be steamed,
fried, creamed or scalloped.
• The thin slicer is suitable for
shredding vegetables for coleslaw,
potato crisps, bread, celery,
cucumbers, nuts and pickles.
• Fit the appropriate shredding or
slicing cones as described above in
assembly instructions.
• Cut the vegetables into cubes of
25mm maximum.
• Feed the cubed vegetables into the
feed tube.
• Use the pusher to move the food
down the tube, no pressure is
required at all.
• Operate the machine on Speed 4.

Cleaning

Before cleaning and maintenance,
switch the appliance off and unplug
from the mains.
1 Remove all attachments. All
attachments can be washed in warm
soapy water. Ensure that they are
thoroughly dried.
www.morphyrichards.com
2 Wipe the outside of the mixer with a
damp cloth, then leave to air dry.
Never use abrasives or immerse in
water.
3 Wash the bowl in hot soapy water.
After cleaning re-fit the bowl. This
will keep the mixer head mechanism
covered.
4 Fill the blender with warm water, fit
the lid and goblet, then switch on to
MAX for 20-30 seconds. Empty then
rinse. Wipe then leave to air dry.
• Do not leave the blender in water to
soak or leave water in the blender.

Top tips

If the mixer stops during operation,
it is because the unit has
overheated due to overloading and
the protection device has activated.
Switch the mixer off and unplug
from the mains.
Remove some of the ingredients to
reduce the load. Let the machine
cool down for 3 minutes.
Plug the unit back in, then reselect
the speed and continue to use. If
the mixer does not restart
immediately, allow to stand for
additional time, then retry.
If the unit is still not working call the
helpline for further advice.