Advertisement
Installation (see Fig1 ~ Fig 6)
⚫
Do not connect the appliance until properly fixed to the wall and the instructions are
fully read.
⚫
The minimum distances must be observed in the diagrams.
⚫
For installation of the appliance, care must be taken not to damage concealed cables.
⚫
Please be careful while drilling the holes.
Wall Mount Instructions
⚫
This appliance is designed to be fixed to a wall at a minimum height of 300mm and the
minimum distance from the top of the heater to the ceiling should be 1000mm. The
wall bracket must be fitted horizontally and the cable routed to the bottom right of the
heater.
⚫
A distance of 600mm from the bottom of the heater to the floor is recommended for
optimum viewing of the fuel bed; see Fig.1 below for recommended fixing
dimensions.
⚫
For optimum viewing, mark the top four screws ( fixing positions on the wall in
accordance with the recommended fixing dimension; See Fig.2
-3-
Note: Ensure the bracket is level by using a spirit level whilst marking out the hole
positions.
⚫
Drill holes with a No.6 drill bit.
⚫
Fix the wall bracket using the plug and 6x25mm screws provided.
⚫
Carefully lift up the heater ensuring the top rear ledge of the heater engages with the
wall bracket(see Fig.2) and is sitting centrally. This process should be carried out by
two people to avoid injury or damage to property or the appliance.
⚫
Put the crystal to the white boarder , then gently bring the heater down against the wall,
see fig.3
Fig.1
-4-
Fig.2
Advertisement
