Advertisement
Binary Input N 260
4 x 230 V AC
Location and Function of the Display and
Operator Elements
A4
Figure 1: Location of the display and operator elements
A1 LED for indicating normal operating mode (LED off)
and addressing mode (LED on); upon receiving the
physical address the device automatically returns to
normal operating mode
A2 Learning button for switching between normal
operating mode and addressing mode for receiving
the physical address
A3 Type plate
A4 Screwless plug-in terminals for connecting input
circuits
A5 Label for noting the physical address
Mounting and Wiring
General description
The N-system DIN-rail device (2 SUs) can be installed to
N-system distribution boards, surface or flush mounted,
or to any DIN-rail EN 50022-35 x 7,5 available that has a
data rail installed.
The connection to the bus line is established by clicking
the device onto the DIN-rail (with a data rail installed).
Take care that the type plates of all devices on a DIN-rail
can be read in the same direction, guaranteeing the
devices are polarised correctly.
Siemens AG
Automation and Drives Group
Electrical Installation Technology
P.O.Box 10 09 53, D-93009 Regensburg
A1
A2
A3
A5
N 260, 4 pages
Siemens AG 2001
Subject to change without prior notice
Technical Product Information
Mounting DIN-rail devices (Figure 2)
Slide the device (B1) onto the DIN-rail (B2) and
-
swivel back the device until the slide clicks into place
-
audibly.
Dismounting DIN-rail devices (Figure 2)
Remove all connected wires,
-
press down the slide (C3) with a screw-driver and
-
swivel the device (C1) from the DIN-rail (C2).
-
B2
C1
B1
Figure 2: Mounting and dismounting a DIN-rail device
Connecting input circuits (Figure 3)
The load circuits are connected via screwless plug-in
-
terminals (D1).
Remove approx. 9 to 10 mm of insulation from the
-
wire (D1.1) and plug it into the terminal (D1).
Conductor cross sections:
• signal inputs, physical:
strip insulation for 9 ... 10 mm
permissible conductor types/cross sections:
0,5 ... 2,5 mm² single core or flexible conductor,
-
8 mm ultrasonically compacted
0,5 ... 2,5 mm² flexible conductor with terminal pin,
-
crimped on gas tight
0,5 ... 1,5 mm² flexible conductor with connector
-
sleeve
1,0 and 1,5 mm² plain flexible conductor
-
Disconnect input circuits (Figure 3)
Press the terminal lock (E1.2) with a screw-driver and
-
remove the wire (E1.1) from the terminal (E1).
-
D1.1
D1
9 ... 10 mm
Figure 3: Connecting and disconnecting wires
Update: http://www.siemens.de/installationstechnik
instabus EIB
September 2001
5WG1 260-1AB01
C2
C3
E1.1
E1.2
E1
Technical Manual
2.7.1.3/3
Advertisement
