Mounting/Dismounting The Screen - JVC DB-HDR36 Instructions Manual

Mounting/Dismounting the Screen

The screen that comes with the main unit can be replaced with an optional screen.
Refer to the catalog for the types of optional screens available.
CAUTION
Before replacing the screen, be sure to turn off the power or press the [HIDE] button on the remote control to hide the
0
image.
When dismounting the screen, take care not to touch the parts inside the main unit such as the mirror. This could cause
0
significant deterioration in the performance of the equipment.
Hold at the frame when carrying the screen. Avoid touching the screen surface. Failure to do so may cause the screen to
0
become dirty.
Avoid applying pressure to the screen. Failure to do so may result in deformation and damage.
0
Mounting the Screen
Insert the two pins inside the top surface of the screen frame into the holes on the top
1
surface of the frame of the main unit
A Place the top edge of the screen frame on the top of the main unit.
B Bring the bending area inside the screen frame to the front side of the frame of the main unit.
Do not place on top of the main unit.
0
C Insert the pin of the screen frame into the hole on the top surface of the frame of the main unit. (Both sides)
(Same for both sides)
Bending Area
.
Insert the two pins on the inner side of the bottom of the screen frame into the holes on
2
the lower frame plate of the main unit
Insert the pins by pushing the lower side of the screen frame.
0
Mount in such a way that the light shielding sponges affixed on the side panels of the main unit are on the inside of
0
the screen frame.
Make sure the screen frame is fully inserted and fitted. (Both sides)
0
(Same for both sides)
Screen
Frame
.
Main Unit - Top Surface of Frame
C
A
B
Screen Frame
Light Shielding
Sponge
Main Unit -
Lower Frame
Plate
45