Other Adjustments And Settings - JVC DB-HDR36 Instructions Manual

Other Adjustments and Settings

RGB Solo
For displaying the RGB component individually.
Pressing the [RGB SOLO] button on the remote control switches the color component as follows.
"All Color" " "Red Component only" " "Green Component only" " "Blue Component only" " "All Color"...
RGB Parade
Pressing the [RGB PARADE] button on the remote control displays the waveform monitor for red, green, blue and all
colors at the bottom of the screen.
Pressing the button again restores the original display.
.
Color Gamut Assist
Pressing the [C.GAMUT] button on the remote control displays the colors that are not correctly displayed by the projector
with the current Picture mode in colors. Colors that are correctly displayed appear in monochrome.
Pressing the button again restores the original display.
* This feature is disabled when "Picture Mode" is set to "Dynamic".
Dim
Pressing the [DIM.] button on the remote control adjusts the brightness to approximately 20 % (depending on the gamma
setting).
Pressing the button again restores the original brightness.
44
Waveform Monitor
100%
75%
For checking the input level.
Top Dashed Line: 235 (8 bit)
50%
Bottom Dashed Line: 16 (8 bit)
25%
0%