Table of Contents
Advertisement
►
Appliance end-of-life
The appliances must be dismantled and recycled by a
specialised service . The appliances must not, under any
circumstances, be thrown out with household waste,
bulky waste or at a tip .
At the end of its service life, please contact your installer
or local representative to proceed with its dismantling
and recycling .
Outside
sensor
Outdoor unit
fig. 1 - Overview of complete installation configuration
Waterstage / OPERATING INSTRUCTIONS / 2010 - EN
Control options
Room thermostat
(wired or radio)
or
Hydraulic unit
►
Overview of the installation
Your heat pump has been configured by your installation
engineer . It is made up of the following main parts:
- The outdoor unit, as its name suggests, is placed
outside your dwelling, and extracts energy from the
outside air .
- The hydraulic unit is located in your boiler room, cellar,
garage or even in your kitchen, and transfers energy to
the heating and domestic hot water circuits* .
- The outside sensor monitors the outside temperature .
Optional:
- Room sensor(s) .
Heat pumps are systems which can be connected to
any type of low temperature distribution system and
the heat captured by the heat pump can be used in
different ways:
- Underfloor heating system.
- Radiators .
- Domestic Hot Water (DHW)* .
and/or
Remote control
Menu
(wired or radio)
Options depending
on hydraulic
configurations
2
circuit kit
Boiler
connection kit
Heating circuit
underfloor heating
Radiators heating
circuit
Boiler
* depending on configuration / option
- 5 -
Hide quick links:
Advertisement
Table of Contents
