Operation And Modes - Klarstein VapoAir Onyx Manual

EN
16

OPERATION AND MODES

Before first Use
• For first Operation, put unit in the room temperature for half of an hour before
running.
• Use clear water not over 40 degree C
• Check the water basin, make sure it is clear.
Getting Started
1. Put the machine on a flat surface.
2. When you take out of the water tank, you must be turn on the child safety lock
3. Fill the water into the water tank, and then tighten the tank cover.
4. Put the water tank on the main base, and turn off the child safety lock.
5. Plug into the socket. The display will be on and show current temperature. After
30 seconds, it switches into current humidity. Temperature and humidity will switch
every 30 seconds. If without any operation for 15 seconds, LED light will become
dark. Press any button, LED be bright and enter related function.
AUTO Mode and Mist Speed
Touch the POWER button
• If lack of water, display will show
• If there is enough water, display will show [AUTO] and current temperature or
humidity, and water tank light will be on.
Device works in AUTO mode. (If it shows humidity before turn off, it will show humidity
when turn on again. But it will switch into temperature after 5 seconds, and switch back
to humidity after 30 seconds.) Touch POWER button again to turn off the device.
Touch the AUTO button
fourth speed for each touch. Touch the fifth times, it enters AUTO mode.
.
and current temperature or humidity.
to out of AUTO mode and the mist start from first speed until