Operation; Maintenance - Klarstein 10028580 Manual

Before operation
• The working environment for humidifier is when:
◦ temp. is between 5 to 40 degree,
◦ relative humidity is lower than 80%RH.
• Use clean water lower than 40 °C ( pure water is recommended)
• Clean water tank and water flume when you use again after a long time.

Operation

1. Lift up the water tank and reverse it, unscrew the nut by wring anticlockwise to open the water tank .
2. Fully fill the water tank with water. Re-screw the nut tight clockwise, and put the water tank back onto the
base stably.
3. Connect to the power, press the "On/Off" button to start the machine.; Press "On/Off" for the 2nd time
to stop the machine .
When waterless, the machine makes alarm and stop working.
Aroma function
1. Pull out the aroma case.
2. Drop aroma oil onto the aroma pad
3. Push back the aroma case into the device, the aroma function will be on automatically when turn on the
device.
Note: To stop the aroma function or when the device is not used for a long time, you should clean and dry the
aroma pad first and then put it back to the aroma case.
Cleaning the transducer
If hard water in some area is used in this machine, water scale is supposed to form on the surface of the trans-
ducer, user should frequently clean the transducer with detergent of oxalic acid imp regnant (or common
brush) according to the following steps:
1. Drop small amount of oxalic acid detergent into the water tank , and load a half of water box.
11
Operation

Maintenance