Using The Blades; Using The Blender - Black & Decker FX800 Instruction Manual

English
• Select the required accessory.
• Make sure that the processor bowl (8) is
locked in position by rotating it in a
clockwise direction.
The chopping blade (14), the knife frame
(13) or the whisk (19) can be placed directly
over the central column of the processor
bowl (8). Rotating these items slowly will
align the hexagonal hole and drive on the
motor spindle (4).
• Add the ingredients and place the lid (10)
on the bowl (8), rotating it clockwise until
it locks in place. The long tab on the lid
(10) will engage in the slot in the upper
housing.
• Connect the appliance to the electrical
supply and select speed 1, 2, 3 or Pulse
as required.
Additional ingredients can be added
through the kidney shaped slot in the bowl
lid (10) after removing the pusher (9). The
pusher must be used to guide the
ingredients into the path of the blade.
Warning! Always use the pusher to assist in
processing food, never use your fingers.

Using the blades

Warning! Make sure the food processor is
unplugged from the power source and
switched off before fitting or removing
accessories.
The blades (14-17 & 21) must be fitted to
the blade carrier (13) before use.
• Place the required blade on the blade
carrier (13), and slide it forward until the
tab fits into the slot. The blade must then
be gently pushed until it locks in
position. To remove the blade, grip the
rim underneath it and pull it away from
the blade carrier (13).
• Once assembled, remove the processor
bowl lid (10) and, using the finger holes in
the blade carrier (13) place the blade
carrier over the motor spindle (4).
• Replace the processor bowl lid (10).
Ingredients can be added through the
kidney-shaped slot in the bowl lid (10) after
removing the pusher (9). The pusher must
be used to guide the ingredients into the
path of the blade.

Using the blender

Use the blender jar (5) for the fine blending
of raw ingredients and blending of cooked
ingredients to a very smooth consistency.
Note: There is a convenient measuring cup
fitted in the blender lid (7).
See the section "Quantities and processing
times" in this manual.
Warning! Make sure the food processor is
unplugged from the power source and
switched off before placing or removing
accessories.
• Remove any accessories from the
processor bowl (8) and refit the lid (10)
and the pusher (9).
• Remove the cap (1) by rotating it in an
anti-clockwise direction.
• Add the ingredients to the blender jar (5)
and fit the lid (7), rotating it in an anti-
clockwise direction until it locks in place.
Do not exceed the maximum mark.
• Place the blender jar (5) in the recess (2)
and rotate it in a clockwise direction until
it locks in place.
Note: The blender jar cannot be fitted to the
appliance unless the lid (7) is correctly fitted
to the jar.
Note: The blender lid (7) cannot be removed
when the blender jar (5) is fitted to the
appliance.
-7-