Removing The Middle Driven Shaft - Yamaha YFM660FR Supplementary Service Manual

1
2
– 26 –
MIDDLE GEAR

REMOVING THE MIDDLE DRIVEN SHAFT

1.Remove:
Nut 1
G
Washer
G
Front drive shaft coupling
G
NOTE:
Use the coupling gear holding tool 2 to hold
the front drive shaft coupling.
Coupling gear holding tool:
P/N. YM-01486, 90890-01486
2.Remove:
Nut 1
G
Washer
G
Coupling gear 2
G
NOTE:
Use the coupling gear/middle shaft tool 3 to
hold the coupling gear.
Coupling gear/middle shaft tool
P/N. YM-01230, 90890-01229
3.Remove:
Bearing housing assembly 1
G
*****************************************************
Removal steps:
G
Clean the outside of the middle driven shaft.
G
Place the middle driven shaft onto a hydrau-
lic press.
CAUTION:
Never directly press the shaft end with a
G
hydraulic press, this will result in damage
to the shaft thread.
Install the suitable socket 2 on the shaft
G
end to protect the thread from damage.
G
Press the shaft end and remove the bearing
housing.
*****************************************************
ENG