Power Cord An OHAUS product service specialist will be available to provide assistance. Outside the Instruction manual USA, please visit our web site, www.ohaus.com to locate the Ohaus office nearest you. Warranty card Serial Number: _______________________________________________________ Date of Purchase: ____________________________________________________...
Upon receiving the Ohaus Multi-Tube Vortexer, check to ensure that no damage has Multi-Tube Vortex Mixers are intended for general laboratory use. The stainless occurred in shipment. It is important that any damage that occurred in transport is steel one piece housing is conducive to keeping your Vortexer clean and free from detected at the time of unpacking.
Page 4
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Changes or modifications not expressly approved by Ohaus Corporation could void the user’s authority to operate the equipment.
Page 5
PecificationS nalog ulti ortexer Overall dimensions (L x W x H): 9.5 x 15.1 x 16” (24.1 x 38.4 x 40.6cm) Electrical (50/60 Hz): 120V 100 watts screw knobs 230V 100 watts Fuses: 120V 5mm x 20mm, 5 amp quick acting 230V 5mm x 20mm, 1 amp quick acting Speed range:...
Page 6
Perating nStructionS nalog ulti ortexer The Multi-Tube Vortexer is used to prepare samples by mixing tubes just prior to testing. 3. Setting speed: a. Turn the speed knob clockwise to the 1 position. IMPORTANT: This unit is designed for intermittent use only. DO NOT operate this unit for b.
PecificationS igital ulti ortexer Overall dimensions (L x W x H): 9.5 x 15.1 x 16” (24.1 x 38.4 x 40.6cm) Electrical (50/60 Hz): 120V 100 watts screw knobs 230V 100 watts Fuses: 120V 5mm x 20mm, 5 amp quick acting 230V 5mm x 20mm, 1 amp quick acting support plate...
Page 8
ontrol anel igital ulti ortexer E. Up/down arrows for set-point control. The front panel of the Multi-Tube Vortexer contains all the switches, controls and displays needed to operate the unit. F. Run/stop buttons: Activates vortexing. A. On/off rocker switch: Turns main power on/off. G.
Page 9
Perating nStructionS igital ulti ortexer The Multi-Tube Vortexer is used to prepare samples by mixing tubes just prior to testing. 5. Setting continuous mode: To run in continuous mode, set the time to zero (0) using the up/down arrows to the IMPORTANT: This unit is designed for intermittent use only.