Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOUROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF
ESSENTIALS SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
GENERAL INSTRUCTIONS:
PREPARING TO INSTALL
CONSULT A LOCAL LICENSED ELECTRICIAN OR ELECTRICAL CONTRACTOR PRIOR TO INSTALLATION.
1.
REVIEW WARNINGS FOUND IN THIS DOCUMENT PRIOR TO STARTING WORK.
2.
INSPECT PACKAGE(S) FOR SIGNS OF DAMAGE. NOTIFY CARRIER IMMEDIATELY FIXTURE PACKAGING IS DAMAGED.
3.
UNPACK THE FIXTURES FROM PACKAGING. RECYCLE AND PROPERLY DISPOSE OF PACKAGING. REMOVE PLASTIC FILM FROM LENS.
4.
INSPECT FIXTURES. IF THERE IS ANY FIXTURE DAMAGE OBSERVED, TAKE PHOTOGRAPHS AND IMMEDIATELY CONTACT LIGHTING.TECH@FLEX.COM.
5.
TURN OFF ELECTRICITY AT THE MAIN CIRCUIT BREAKER, PANELBOARD, FUSE BOX OR DISCONNECT.
6.
DO NOT ATTEMPT TO INSTALL FIXTURE WITH THE POWER ON.
MAKE SURE THE MOUNTING SURFACE IS CAPABLE OF SUPPORTING WEIGHT OF FIXTURE.
7.
MAX AMBIENT REDUCED 5°C WHEN MOUNTED NEAR CEILING.
8.
ENSURE PROPER AIRFLOW AROUND FIXTURE.
9.
CABLE READY MOUNT
PREPARING TO INSTALL
REFER TO GENERAL INSTRUCTIONS AT THE BEGINNING OF THIS SECTION.
1.
IF FIXTURE HAS A CORD, CHECK TO ENSURE CORD GROMMET IS TIGHT. IF NOT TIGHT, NOTIFY LIGHTING.TECH@FLEX.COM IMMEDIATELY
2.
SECURE SUSPENSION CABLE TO STRUCTURE. (ORDERED SEPARATELY – CABLEKIT OR CABLEKITSS FOR 2W MODEL OR CABLEKIT2P OR CABLEKIT2PSS FOR
3.
2N AND 4N MODELS) OR CHAIN (NOT INCLUDED).
ATTACH SUSPENSION CABLE OR CHAIN TO BAIL HOOKS (2N AND 4N MODELS ONLY, FIG. 1) OR MOUNTING TABS (2W MODEL ONLY, FIG. 2).
4.
MAKE FINAL WIRING CONNECTIONS (REFER TO WIRING INSTRUCTIONS AT THE END OF THIS SECTION).
5.
FIG. 1
FLEXLIGHTINGSOLUTIONS.COM
REV 082318
LIGHTING.TECH@FLEXTRONICS.COM
HOSEDOWN SERIES
FIG. 2
913.851.3000
Advertisement
