Check Record; Signal Route - Panasonic KX-TG2323AGB Service Manual

11.3. Check Record

BASE UNIT
a) Not record Greeting Message
b) Not record Incoming Message
c) How to change the Auto Disconnect activation (time)
Some Telephone Company lines (fiber or cable) ON Hook and OFF Hook voltages are lower than conventional lines, which may
cause a malfunction of Auto Disconnect detection.To solve this problem, try changing the Auto Disconnect activation (time)
through the procedures below.
Auto Disconnect activation (time)
Enable 2 sec [default]
4 sec
Disable*
*If the "Disable" is selected, even if the parallel-connected telephone is OFF HOOK, the line isn't disconnected.
d) How to change the VOX level
VOX Level
Normal
-10 dB Down
Cross Reference:
SIGNAL ROUTE (P.67)
Telephone Line Interface (P.59)
Auto Disconnect Circuit (P.60)
Parallel Connection Detect Circuit (P.61)
"STOP"→"GREETING CHK"+"[LOCATOR]" simultaneously
"STOP"→"GREETING CHK"+"[ ]" simultaneously
"STOP"→"GREETING CHK"+"[ ]" simultaneously
"STOP"+"LOCATOR"+"VOLUME " simultaneously
"STOP"+"LOCATOR"+"VOLUME " simultaneously
Note:
29
PROCEDURE
PROCEDURE
Flash Memory is IC701.
DSP is IC501.
KX-TG2323AGB / KX-TGA231AGB
Status
Stand-by