Advertisement

04/2013
Mod:ST40A/D-N ST70/AD-N
Production code: SE-40M SE-70M

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ST40A/D-N and is the answer not in the manual?

Questions and answers

Summary of Contents for Diamond ST40A/D-N

  • Page 1 04/2013 Mod:ST40A/D-N ST70/AD-N Production code: SE-40M SE-70M...
  • Page 2: Table Of Contents

    CONTENT Declaration of a standart confirmity Technical data Instalation Placement of the device Chart Connection of the electric cable to electricity Maintenance Instructions for use Comments and reccommendations Cleaning and maintenance Process in case of wrong function of the device...
  • Page 3: Technical Data

    DECLARATION OF A STANDARDS CONFORMITY The producer confirms that the devices agree with CEE 90/396 standards,rule nr. 22/1997 sb. and with relevant goverment orders. Instalation must be done with respect to valid standards. Attention, the producer refuses any responsibility in case of direct or indirect damages which are caused due to wrong instalation, incorrect intervention or modification, insufficient maintenance, incorrect use and also possibly caused by other reasons presented by items in sale conditions.
  • Page 4: Instalation

    PACKING AND DEVICE CHECK The device leaves our stocks properly packed with appropriate symbols and labels. There are also appropriate instructions for use. In case the packing shows bad handling or damage, it must be reclaimed at transporter immediately by writing and signing of a damage protocol. Important notice •...
  • Page 5: Chart

    Important Any activity connected with regulation etc. must be done only when the device is disconnected from electricity. If it is necessary to have the device connected to the electricity (durig regulation) you must be very careful. PLACEMENT The device must be instalated in well ventilated room what is necessary for regulation of the function of the device (technician must go by valid standard ČSN..).
  • Page 6: Connection Of The Electric Cable To Electricity

    A noncombustible granit, sandstone, concretes,bricks, ceramic wallfacing tiles, plaster B uneasily combustible akumine, heraklite, lihnos, itavere C1 hardly combustible leafy wood, plywood, sirkoklit, rare paper,formica C2 middle combustible fibreboards, solodure, cork boards, rubber,floor- coverings C3 easily combustible wood-fibreboards, polystyrene,polyurethane, PVC Devices must be instalated in a safe way.
  • Page 7: Maintenance

    We refuse any responsibility in case of not respecting above mentioned rules. Before the first use it is necessary to remove all the protection foil and to clean the device - see chapter "cleaning and maintenance". We recommend you to leave the device work empty for 15-20 min when switching it on for the first time because in produces bad smell and smoke.
  • Page 8 Indication Guarentee does not cover all consumption parts succumable to common wear (rubber seals, bulbs, glas and plastic parts etc.). The guarantee does not refer to the devices which were not instaled in correspondance with instructions - by qualified worker, in confirmity with standards and when somebody handled incompetently the device (interventions into inner equipment) or the device was operated by nonqualified staff or at variance with instructions for use.
  • Page 9 WIRING DIAGRAM: SE – 40 S,M 230 V/50 1 – Terminal board 2 – Rheostat 3 – Control light (green) 4 – Heating element 5 – Control light (yellow)
  • Page 10 WIRING DIAGRAM: SE – 70 S,M 1 – Terminal board 2 – Rheostat 3 – Control light (green) 4 – Heating element 5 – Control light (yellow)

This manual is also suitable for:

St70a/d-nSe 40sSe 70sSe 40mSe 70m

Table of Contents