Advertisement
9. Draw the VPR-101 board approximately 30
mm out of the unit, and disconnect the har-
ness (AXM-VPR) from the connector CN600.
10. Loosen the screw with stopper to detach the
cable stopper (30P).
11. Disconnect the fi ne-wire coaxial cable from
the connector CN2100 on the VPR-101 board
using the cable stopper (30P). (Refer to
Section 1-4-1.)
m
. Disconnect the fi ne-wire coaxial cable
using the procedure described in Section
1-4-1.
. Never pull the fi ne-wire coaxial cable.
12. Loosen the screw with stopper to detach the
cable stopper (BNC).
13. Disconnect the fi ne-wire coaxial cable from
the connector CN2101 on the VPR-101 board
using the cable stopper (30P). (Refer to
Section 1-4-1.)
14. Loosen the screw with stopper to detach the
cable stopper (BNC-2).
15. When the HKSR-9001 is installed in the unit,
disconnect the three coaxial cables from the
connectors CN1012, CN1010, and CN1011
on the TR-139 board using the cable stopper
(BNC). (Refer to Section 1-4-2.)
16. Remove the VPR-101 board from the unit.
n
Be very careful so that the harnesses and
cables are not caught.
1-4 (E)
Harness
(AXM-VPR)
Cable stopper (30P)
Screws with stopper
Coaxial cables
Cable stopper
(BNC-2)
Bainding
bands
Cable stopper
(BNC)
Screw with stopper
30 mm
VPR-101 board
CN2100
Fine-wire
coaxial cables
Gold
CN2101
Installed in HKSR-9001
TR-139 board
coaxial cable
Blue
Gray
Red
CN600
Gold
CN1011
CN1010
CN1012
HKSR-9003
Advertisement
