Control Panel - Flex ADL 30 Original Operating Instructions

FLEX ADL 30/60/120

Control panel

14 Display
15 Reference button
For transferring angles. The display jumps
to ° and REF flashes on the display.
0.0
To delete the reference value, switch off
the spirit level.
16 On/Off button
Switches the power tool on and off.
When the measuring instrument has been
switched on, the current ambient tempera-
ture is briefly displayed in °C.
To switch off the measuring instrument,
hold down the button for approx.
3 seconds.
14
17 Signal button
Switches the acoustic signal off and on.
If the angle of inclination is on 0°, 45°, 90°
or the last saved value, this is signalled
acoustically. Note: When the angle
reference value (13) is activated, this
becomes the signalling zero point.
18 Save button
Saves the currently displayed measured
value (9 storage locations).
Attention: When another value is saved,
the previous 9 measurements are deleted.
19 Unit of measurement button
Switches the units of measurement
in succession: °, in/ft, %.
When the measuring instrument has been
switched on, the display in ° is always
active.
20 Memory recall button
Displays the saved measured values,
starting with the measured value last
saved.