Table of Contents
Advertisement
Attaching the connecting plate will align
the appliances in depth.
If one of the appliances protrudes
further forward than the other, start with
the further forward appliance:
^ Position connecting plate g so that
the vertical slots are on the side of
the panel which will be attached to
an appliance first. Attach it loosely
with two screws h.
^ Push connecting plate g until the
central ridge on the bracket touches
the side of the appliance.
^ Now tighten both screws h.
^ Secure connecting plate g to the
other appliance. To do this push the
appliances together a little, as
necessary.
Installing in a side-by-side combination
Installation steps at the back of the
appliances
^ Fit connecting bracket i onto the
top of the sides in the middle.
^ Fit connecting piece j into the
relevant gap below.
^ Tighten connecting piece j using
screw k supplied.
Warning: Do not drill a hole in the
appliance for this screw.
To avoid vibrations, the connecting
bracket, connecting piece and
screw must not touch the pipework
at the back of the appliances.
69
Advertisement
Table of Contents
