Table of Contents
Advertisement
Problem solving guide
. . . "nA" appears in the temperature
display.
The temperature has risen too high at
some point during the last couple of
days because of a power cut.
^ Touch the alarm off sensor whilst "nA"
is lit up in the display.
The temperature display will show the
warmest temperature recorded in the
freezer section during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer. If it has
defrosted or started to defrost, check
that it is still safe to use and, if so, use it
as soon as possible. Defrosted food
may only be refrozen after it has been
cooked.
The warmest temperature will show in
the display for about 1 minute. The
current temperature in the freezer will
then show in the display again.
54
. . . "dn" appears in the display.
The demonstration function is activated.
^ Call the Miele Service Department.
. . . you cannot switch the ice cube
maker on.
^ Check whether the appliance is
connected to the electricity supply.
. . . the ice cube maker is not
producing any ice cubes.
^ Was the water inlet pipe purged of air
by a qualified and competent person
before the appliance was used for
the first time?
^ Check whether the ice cube maker is
switched on.
^ Check whether the freezer section is
switched on.
^ Check that the water inlet is open.
^ Check that the ice cube drawer has
been closed properly.
It can take up to 24 hours to produce
the first ice cubes.
^ Check the mains water connection
and clean the filter between the
stainless steel hose and the stopcock
and the filter between the stainless
steel hose and the solenoid valve on
the appliance (see "Mains water
connection").
Advertisement
Table of Contents
