ENGINE CHOKE CONTROL
(SELECT UNITS)
Choke Cable Replacement
On units with a dash-mounted engine choke control, the
control is a push-pull button mounted on the lower left
portion of the dash assembly (Figure 2). For easiest
service access, the battery should be removed from the
unit.
1. Loosen the choke cable clamp on the engine using a
phillips head screwdriver, and after noting the
engagement of the cable end with the choke lever,
remove the cable end from the choke lever (Figure
3).
2. From inside the dashboard area, unscrew the hex nut
that secures the choke cable assembly to the dash,
and slide the choke cable and handle assembly out
of the front of the dash.
3. Inspect all parts for wear or damage, and replace as
required.
4. Reassemble parts in reverse order of disassembly.
5. Check engine choke linkage for proper engagement
with cable, and smooth operation of choke. See
engine manufacturer's instructions for complete
choke adjustment instructions.
10 Hand Controls Service
Engine Choke
Control
Figure 2. Engine Choke Control Location
Cable End
Figure 3. Disconnect Choke Cable At Engine
Choke Cable
To
Engine
Figure 4. Choke Cable Assembly
10 - 3
Choke Control Service
Choke Lever
Choke Handle
Lockwasher
Hex Nut