Table of Contents
Advertisement
3. Attach the right and left adapters to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adapter.)
B4 x 10
3U
4. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adapter
completely (the screws that were loosened in step 2).
5. Align the groove of the rack tool at the side of the
equipment with the rail, and slide the equipment to the
rear.
n
The rack tools are hooked on the rails as shown below.
Rack tool
Rail
1-10 (E)
31.75
B4 x 10
31.75
Unit : mm
Rack tool
Rail
6. Turn off the main power of this unit and disconnect the
plug from the outlet.
7. Fully loosen the four screws (with drop-safe) and
remove the front panel.
B4 x 10
(with drop-safe)
B4 x 10
(with drop-safe)
Front panel
8. Fix the rack angle in the rack using the specified
screws.
B5 x 12
9. Attach the front panel to the equipment.
1-8. Installing the BKE-701A
For the installation procedure, refer to "4. Installing the
BKE-701A" of the Installation Manual supplied with the
BKE-701A.
B4 x 10
(with drop-safe)
B5 x 12
BVE-700A
Advertisement
Table of Contents
