Table of Contents
Advertisement
en Home Connect
Deactivating Wi-Fi on the ap-
pliance
Press and hold Remote Start
1.
at least three seconds.
Set the programme to position 4.
2.
→ "Overview of Home Connect set-
tings", Page 38
a The display shows Con .
Press Start / Reload repeatedly until
3.
the display shows OFF .
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected to
your home network, this connection will
be re-established automatically when
Wi-Fi is switched back on.
Resetting the appliance net-
work settings
Press and hold Remote Start
1.
at least 3 seconds.
Set the programme to position 5.
2.
→ "Overview of Home Connect set-
tings", Page 38
a The display shows rES .
Press Start / Reload .
3.
a The display shows .
Press Start / Reload .
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
Tip: If you wish to operate your appli-
ance again via the Home Connect app,
you will need to reconnect it to the Wi-
Fi and to the Home Connect app.
Software update
Requirement: The display shows UdP .
Press and hold Remote Start
1.
approx. 3 seconds.
42
Set the programme to position 6.
2.
→ "Overview of Home Connect set-
tings", Page 38
for
a UPd appears on the display.
Press Start / Reload .
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update is
in progress.
Connecting the appliance to
the energy manager
If you connect the appliance to the
smart energy system (energy man-
ager), you will optimise your energy
consumption. The appliance starts only
when your home photovoltaic system
can provide sufficient energy or the en-
for
ergy tariff is good.
Requirements
¡ The smart energy system (energy
manager) must use the EEBus Initiat-
ive communications standard.
¡ You have read about how to connect
your appliance to the smart energy
system (energy manager) in the in-
struction manual for the smart en-
ergy system (energy manager).
Press and hold Remote Start
1.
approx. 3 seconds.
a The display shows Aut .
Set the programme to position 7.
2.
→ "Overview of Home Connect set-
tings", Page 38
a The display shows EnG .
Press Start / Reload .
3.
a The appliance is connected to the
smart energy system (energy man-
for
ager).
a If the appliance has connected to
the energy manager successfully,
the display shows and .
for
Advertisement
Table of Contents
