Addonics Technologies Jasper II 1S JD2-325SN User Manual

Default settings on the duplicator:
Copy – set to copy system and file. This is for drives that have the following
file system: NTFS, FAT/16/32, eXFAT, HFS, EXT3/4 or XFS. For other file
systems and boot drives, you may need to change the setting to WHOLE
MEDIA
Performance – set to SPEED for best performance. May encountered
compatibility issue with certain SSD. Should that occur, try to change the
setting to BALANCE or COMPATIBILITY.
HPA – set to SKIP.
Please review the Jasper II Duplicator user guide for all the detail settings.
Making duplicates
Power up the unit by pressing on the ON/OFF button at the front lower right
hand corner. Once the unit is ready, the LCD should display
HDD Duplicator
1. Copy
The unit is now ready. Simply load a source drive to the source slot (the first
bay on the top) and the target drive to the target slot (the lower bay). After a
few seconds, the LCD should display the number of target drives detected.
Press the OK button on the LCM control panel to start the copying.
Note: some drives may not be detected correctly. In that case, please leave the
drive inside the unit and re-start the duplicator.
CONTACT US
www.addonics.com
Phone: 408-573-8580
Fax: 408-573-8588
Email: http://www.addonics.com/sales/query/
Jasper II 1S – 1:1 3.5"/2.5" HDD/SSD
High Speed duplicator
Model: JD2-325SN
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/