Supero Dual Processor AS 1020C-3 User Manual page 84

AS1020C-3 User's Manual
Parallel Port Address
This option specifi es the I/O address used by the parallel port. Select Disabled to
prevent the parallel port from accessing any system resources. When the value of
this option is set to Disabled, the printer port becomes unavailable. Select 378 to
allow the parallel port to use 378 as its I/O port address. The majority of parallel
ports on computer systems use IRQ7 and I/O Port 378H as the standard setting.
Select 278 to allow the parallel port to use 278 as its I/O port address. Select 3BC
to allow the parallel port to use 3BC as its I/O port address.
Parallel Port Mode
This feature allows you to specify the parallel port mode. The options are
Normal, Bi-Directional, ECP, EPP and ECP & EPP.
Parallel Port IRQ
Select the IRQ (interrupt request) for the parallel port. The options are IRQ5
and IRQ7.
KBC Clock Rate
This settings for the KBC Clock rate are 6 MHz, 8 MHz, 12 MHz and 16 MHz.
Hyper Transport Confi guration
CPU0: CPU1 HT Link1 Speed
The HT link will run at the speed specifi ed in this setting if it is slower than or
equal to the system clock and if the board is capable. Options are Auto, 200
MHz, 400 MHz, 600 MHz, 800 MHz and 1 GHz.
CPU0: CPU1 HT Link1 Width
The HT link will run at the width specifi ed in this setting. Options are Auto, 2
bit, 4 bit, 8 bit and 16 bit.
CPU0: PCI-X0 HT Link Speed
The HT link will run at the speed specifi ed in this setting if it is slower than or
equal to the system clock and if the board is capable. Options are Auto, 200
MHz, 400 MHz, 600 MHz, 800 MHz and 1 GHz.
CPU0: PCI-X0 HT Link Width
The HT link will run at the width specifi ed in this setting. Options are Auto, 2
bit, 4 bit, 8 bit and 16 bit.\
7-10