Accessing The Drive Bays - Supero Dual Processor AS 1020C-3 User Manual

Figure 6-3. Removing the Front Bezel

Accessing the Drive Bays

SAS Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace SAS drives.
Proceed to the next step for instructions.
CD-ROM/Floppy Disk Drives: For installing/removing a CD-ROM or fl oppy disk
drive, you will need to gain access to the inside of the 1020C-3 by removing the
top cover of the chassis. Proceed to the "CD-ROM and Floppy Drive Installation"
section later in this chapter for instructions.
Note: Only a "slim" CD-ROM drive will fi t into the 1020C-3.
Chapter 6: Advanced Chassis Setup
1. Unlock
2. Press release knob
3. Remove bezel assembly
6-5