Jet GH-1640 ZX Operating Instructions Manual page 13

DIN 51517-2 CL ISO VG 32
(e.g. BP Energol HLP32, Castrol Hyspin AWS 32, Mobil DTE
Oil Light )
Oil must be up to indicator mark in oil sight glass (A, Fig
22).
Fill oil by pulling plug located on top of the headstock
underneath the rubber mat.
Drain oil after first month of operation by removing drain
plug on the left side of the headstock at the lower rear
corner.
Clan out any metal shavings.
Refill with oil.
Then change the oil in the headstock annually (respectively
every 700 operating hours).
- Gearbox:
Change the hydraulic oil (1,8 litre)
DIN 51517-2 CL ISO VG 68
(e.g. BP Energol HLP68, Castrol Hyspin AWS 68, Mobil DTE
Oil Heavy Medium)
Oil must be up to indicator mark in oil sight glass (B, Fig
22).
Fill oil by removing 2 screws on the top cover.
Drain oil after first month of operation by removing drain
plug (C, Fig 22). Refill with oil.
Then change the oil in the gearbox annually (respectively
every 700 operating hours).
- Apron:
Change the hydraulic oil (1,5 litre)
DIN 51517-2 CL ISO VG 68
Fig 22
(e.g. BP Energol HLP68, Castrol Hyspin AWS 68, Mobil DTE
Oil Heavy Medium)
Oil must be up to indicator mark in oil sight glass (A, Fig
23).
Fill oil by removing plug (B).
Drain oil after first moth of operation by removing drain
plug on the bottom. Refill with oil.
Then change the oil in the apron annually (respectively
every 700 operating hours).
One shot lubrication system:
Daily pull knob (C) on the one shot lubrication system and
hold for several seconds to allow oil to fill the pump. When
the knob is released, oil will flow through various oil lines to
lubricate the ways and cross slide surfaces.
When the oil level is below the indicator mark, oil must be
added.
8.2 Weekly Lubrication
Weekly inspect the oil sight glasses, fill oil on demand (see
8.1).
Weekly apply grease:
DIN 51807-1 non slinging grease
(e.g. BP L2, Mobilgrease Special).
- Rack
Apply grease on entire length.
- Change gears
Coat all gears with grease
8.3 Daily Lubrication
Daily operate the apron one-shot lubrication system
(chapter 8.1)
15
Fig 23