Self-Test Stage 2 - Raymarine ST40 Service Manual

Message
FAIL 8
FAIL 18
If there is no audible beep, check TR19(b) and RN3 and the buzzer for damage. If the
beep volume is low, check R93.
Press the

Self-test stage 2

When entering self test stage 2, the instrument beeps and the display shows TEST 2,
for 1 second. The following tests are then performed automatically:
• The display backlighting cycles between on and off every second.
• A display test is performed. The LCD segments are displayed in the following
CAL
STEER
While this test is progressing, press each of the front panel keys and check that the
buzzer sounds as each key is pressed.
If any problems occur, use the following table as a guide to try to remedy the
problem:
Failure
No illumination
No beep when key pressed
LCD segment(s) missing completely
Faint LCD segments
Press the
2-30
Failure Mode
SeaTalk Rx/Tx
EEPROM failure
and keys together momentarily, to proceed to self-test stage 2.
sequence, changing once per second:
and keys together momentarily, to proceed to self-test stage 3.
Action
Check for damaged bucket connectors/rear-case pins.
Check SeaTalk interface components around TR1, TR2 and TR3.
Replace EEPROM (IC2)
Action
Check TR18 and associated components.
Check all LEDs.
Replace keyswitch.
Check LCD pins for poor/dry joints.
Check IC7 pins for poor/dry joints.
Check LCD for short circuited pins.
Check IC7 for short circuited pins.
Check the contrast drive circuit around TR6.
ST40 Instruments Service Manual 83149-2
Part 2 Instrument Servicing
D4888-1