Ilsintech SWIFT K11 User Manual page 41

[Set values editable within mode]
Set value Description
Optical fiber type It displays the list of splice mode saved on sealer data to
facilitate selection of a proper mode to use.
Among splice modes saved on database, it copies a similar
splice mode to use editing function.
Mode title 1 Mode title 1 is to indicate splice mode within 11 letters at
maximum.
Eccentricity When arraying optical fiber by using eccentricity adjustment
adjustment function, it sets offset ratio of axis.
function
Automatic power The closer it is arrayed to the core center
the quicker and better the discharge is done.
Tensile force test It conducts tensile force test after splice.
Cutting angle It sets cutting angle's error bound.
limit
When either of cutting angles on both optical fiber is outside
the bound, error message is displayed.
Limit on It sets estimated loss value's error bound.
estimated loss
When estimated loss is higher than the bound, error message
value
is displayed.
Limit on optical When the bending of 2 spliced optical fibers exceeds the set
fiber angle bound, error message is displayed.
Cleaning A short cleaning discharge is conducted to remove fine dust
discharge on optical fiber's surface upon initial stage of optical fiber
amount arrayal. It sets intensity of cleaning discharge.
Cleaning It sets time for cleaning discharge.
discharge
Clearance Upon final arrayal, it sets clearance of cross section between
both optical fibers.
Clearance It sets location of optical fiber spliced at the center of
location discharge.
When MFD of both optical fibers differs, do the sealing
procedure through melting the smaller MFD optical fiber
more than the bigger MFD optical fiber. To heat the smaller
MFD optical fiber more, splice loss can be lowered by moving
the clearance location toward the bigger MFD optical fiber at
the center of discharge.
Initial It sets initial discharge amount from the beginning of
discharge before optical fiber's advance. If the value of initial
discharge amount is too low, the angle of optical fiber's cross
SWIFT K11-EN, Rev.A
General
mode
Editable
Uneditable
with fewer errors ,
Editable
Uneditable
Editable
Uneditable
User mode
Editable
41