Picture Id - LG 43SH7E Owner's Manual

Picture ID

AUDIO
(RGB/DVI)
RS-232C OUT
Picture ID is used to change the settings of a specific set (display) using a single IR receiver for multi-vision.
Communication is possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each
RS-232C IN
REMOTE
monitor is identified by a Set ID. Setting
CONTROL IN
ID that matches the Picture
1
Assign Set ID to the installed monitors as shown below:
2
Picture ID
Press the red
3
Make sure that the Picture ID you set is identical to the
• A set with a Set ID that is different from the
NOTE
• If Picture ID has been set to 2, only the upper right monitor, which has a
• If you press the green Picture ID
you then press any button on the remote control, all monitors can be controlled by IR signals regardless of their
ID's.
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
Picture ID allows you to only use the remote control with monitors with a
ID.
On button on the remote control.
Picture ID
Off button on your remote control, the
Set ID
of the monitory you wish to control.
cannot be controlled by IR signals.
Set ID of 2, can be controlled by IR signals.
Picture ID for all monitors are turned off. If
45
Set
Set