Table of Contents
Advertisement
4. Status announcements
Demo-jumper:
The LightControl has a TEST SELF or DEMO with its activation all ports a run
light spend. With this function all ports of the LightControl can be tested.
Preparation:
Close the 2pole pin row JP2 with a Jumper.
also EXTRA:
If you close one of the 8 inputs one of the power exits shines independent of the run light permanently up
to again open of the input. so you can also test the functionally of the inputs.
Important:
Don´t forget to open the „DEMO Jumper" after the test, before you transfer a macro to the Lightcontrol.
Otherwise the DEMO mode macro will be deleted.
Key combination for Bootloader:
Manual to build the SMD pre fitted Hardware
Approach:
Connect the Lightcontrol to yout power
supply and connect the LED and Power
outputs to a luminous-medium. When closing
the DEMO Jumper. With close of the jumper
"DEMO jumper " a run light is given
regardless of the stored macros to the power
and LED exits.
So you can detect defect ports..
yes
Demo-Jumper inserted?
yes
FTDI Bootloader
Bootloader
button S1 pressed?
no
Application forward
no
BiDiB Bootloader
manual-Version V1.4-en
page 15
Advertisement
Table of Contents
