Table of Contents
Advertisement
Step 4:
In the last step the folder must be selected in which the firmware file lightcontrol_update_xxxxxx.000.hex
is stored and this must be transferredWith close of the window the LightControl is updated to the new
firmware and is ready for operation.
Tip:
With an update of the LightControl only the special marked update ....001.hex file shoul be used,
otherwise all macro and port settings on the LightControl get lost. (default settings)
Manual to build the SMD pre fitted Hardware
Step 1:
The LightControl is connected to the care tension and is
also connected to the BiDiBus.
Step 2:
Open the BiDiB-Wizard tool and in the knot list the
serialnumber of the interface (master GBMboost) and
the LightControl should be visible.
Step 3:
With the right mouse key click on the serialnumber of
the LightControl and select in the pop-up menu the
action"Firmware Update".
manual-Version V1.4-en
page 14
Advertisement
Table of Contents
