Step 4: 16 Power Outputs And 8 Inputs; Step 5: 32X Led-Outputs - Fichtelbahn OpenDCC BiDiB LightControl V1.3 Manual

step 4:
16 Power outputs and 8 inputs
These 16 exits are suited for lighting effects with light bulbs,
also switch from bigger load max. to 300 mA per output or
for magnet articles.
For this the tub plugs SV2 and SV1 must be soldered for the
power outputs and SV5 for 8 inputs.
Please, follow the right installation direction
(see photo). With the tub plugs SV2 and SV1 the outer bore
row remains free!
step 5:
32x LED-outputs:
These 32 LED-outputs can be used for signal signs also for lighning effects.
With both Potis R34 and R36 you can change
the basic brightness of the respective driver
(power source).
The light-emitting diodes are connected in the
tub plugs SV3 and SV4. These must be still
soldered, besides, follow the right installation
direction (see photo)
Beside the tub plugs (bottom side) there are
still the solder jumpers SJ10, SJ11, SJ12
and SJ13, with it you can determine the
supply voltage for the LED.
We recommend for a supply without
dropping resistor 5 V of potential.
With several light-emitting diodes in row
per exit one needs 16 V variation.
Here the LEDs should be used with
dropping resistor.
Manual to build the SMD pre fitted Hardware manual-Version V1.4-en page 11